Welcome to iraf.net Monday, May 13 2024 @ 06:22 PM GMT
| massey |
05/12/2012 07:13PM (Read 1892 times)
|
|
|
Status: offline
Registered: 02/10/2006
Posts: 162
|
A colleague asked me this, and I didn't have a good answer for her. I suspect this is an issue that goes beyond splot."'I've noticed a couple of times that if I exit splot catastrophically, i.e. I hit an incorrect key and have to get out of splot and back in, I lose the results accumulated in my log file since the
last time I started splot. Is there something I can do that will
save the log file as I work?"
|
| |
|
|
| fitz |
|
05/12/2012 07:13PM
|
|
|
Status: offline
Registered: 09/30/2005
Posts: 4040
|
Hi Phil,It's probably just a case of I/O buffering not syncing to disk before task exits (abnormally). I've added a flag in the next update so the log file gets flushed each time it is written to, until then you would need to periodically use ":nolog" and ":log" to close (and flush) the file then reopen it for appending, i.e. to checkpoint the results written so far.-Mike
|
| |
|
|
| |
|
| Content generated in: 0.06 seconds |
|
New Topic
Post Reply
splot log files
Quote
