Welcome to iraf.net Thursday, May 02 2024 @ 01:11 PM GMT
Hawkmoon |
05/28/2019 04:57PM (Read 616 times)
|
|
|
Status: offline
Registered: 05/28/2019
Posts: 1
|
Hello all,
Whenever I try to run eqwidth, I always get an index1 and eqwidth1 of 0. Below is my bandpass file info. and the output when I run the task.
halpha 6500 10 none line 7000 10 none
spectrum band1 flux1 cont1 cflux1 index1 eqwidth1
---------- ------- -------- ------- -------- -------- --------
clean9.fit[0] halpha 7.04303 cont 7.99417 0. 0.
My parameters are set to normalize the bandpass response. I'm hoping this is just a simple issue with formatting rather than a problem with the spectrum I'm using. If I need to upload anything else just let me know. Any help is appreciated.
|
|
|
|
| |
|
Content generated in: 0.05 seconds |
|