Welcome to iraf.net Thursday, May 02 2024 @ 12:21 AM GMT
| Anonymous: Guest |
01/17/2006 07:23PM (Read 3594 times)
|
|
|
|
|
Hi--
Ran into a problem installing ximtool into RedHat 9. The error message
is as follows:"Incorrectly built binary which accesses errno, h_errno, or -res directly.
Needs to be fixed"Installing from x11iraf-v1.3.1-bin.redhat.tar.gzI can display an image into the result from this installation,
but cannot control anything in image.Grateful for advice.Cheers, Drew
|
| |
|
|
| fitz |
|
01/17/2006 07:23PM
|
|
|
Status: offline
Registered: 09/30/2005
Posts: 4040
|
This is a known problem on RH9 and newer systems that can be fixed by using the X11IRAF V1.3.2 snapshot release available fromftp://iraf.noao.edu/pub/fitz/x11iraf-v1.3.2-bin.redhat.tar.gzAs for the "control" problem, be sure the NumLock key is not enabled, this changes the event mask and keeps the contrast stretching and menus from working.-Mike
|
| |
|
|
| |
|
| Content generated in: 0.08 seconds |
|
New Topic
Post Reply
ximtool and Red Hat 9
Quote
