Welcome to iraf.net Thursday, May 02 2024 @ 09:25 PM GMT
NUMBER: 544 MODULE: echelle.scombine SYSTEM: V2.12.2 DATE: Wed Jan 19 08:44:47 MST 2005 FROM: valdes BUG: Changes to SCOMBINE in V2.12.2a made it a separate executable. The ECHELLE package definitions, however, failed to be updated so when trying to run SCOMBINE from the echelle package the following error message is produced. ERROR: task `scombine' has no param file The solution is editing the echelle$echelle.cl file so that it reads as shown below. A simpler workaround is to load the onedspec package and run scombine from that package. STATUS: Fixed for the next release. Modifications to echelle$echelle.cl: ... task continuum, deredden, dispcor, dopcor, ecidentify, ecreidentify, refspectra, sapertures, sarith, sflip, slist, specplot, specshift, splot = 'onedspec$x_onedspec.e' task scombine = 'onedspec$scombine/x_scombine.e' ... Note that scombine has to be removed from the first block of task definitions and added as a separate task statement. NUMBER: 547 (see also 544) MODULE: argus, ctioslit, hydra, iids, irs, kpnocoude, kpnoslit SYSTEM: V2.12a-V2.12b DATE: Mon Apr 25 10:59:24 MST 2005 FROM: valdes BUG: Changes to SCOMBINE in V2.12.2a made it a separate executable. The package definitions for the packages listed above (see also number 544 concerning the ECHELLE package) failed to be updated so when trying to run SCOMBINE (or a task that calls SCOMBINE such as DOHYDRA) the following error message is produced. ERROR: task `scombine' has no param file The solution is editing the$ .cl file, where is one of the modules listed above, so that it reads as shown below. A simpler workaround is to load the onedspec package and run scombine from that package. STATUS: Fixed for the next release. Modifications to $ .cl: ... task ..., [scombine,] <-- Delete line ..., ... = onedspec$x_onedspec.e task scombine = 'onedspec$scombine/x_scombine.e' <-- Add line ... Note that scombine has to be removed from the first block of task definitions and added as a separate task statement as shown.
The following comments are owned by whomever posted them. This site is not responsible for what they say.