iraf.net

NUMBER:	297
MODULE:	longslit, longslit.identify, longslit.reidentify
SYSTEM:	V2.10.0
DATE:	Mon Jun 19 14:08:46 MST 1995
FROM:	valdes

BUG:	This is a tardy bug report since I noticed this major bug is not
	actually in the bug log.  In the first release of V2.10 there was
	a serious bug in the ONEDSPEC tasks which apply to 2D images such
	as long slit data.  The tools would not access dispersion lines
	beyond 2.  The most common symtom is that IDENTIFY will only
	show lines 1 and 2 in long slit data.  Normally one encounters
	this in the LONGSLIT package.  If one uses a section parameter of
	'middle lines' IDENTIFY will show the image section [*,2].
	REIDENTIFY is similarly limited to the first two dispersion lines.
	There is no workaround other than to upgrade V2.10 to any
	higher version.  It was first fixed in V2.10.1


STATUS:	Fixed in V2.10.1 and later.